How To Box In Around Pipes And Piping

Boxing in Pipes

Difficulty Levels
The task is merely regarding decoration reasons and does not contain anything far too technical

Listing of tools essential
Tenon Saws
Power Drill and attachments
Particle board or MDF
Various Hand Tools
12mm thick square batten
Ruler / tape measure
Pencil
Screws
Rawl plugs (a plastic socket inserted in to a drilled hole before the screw is pushed in. Holds the screw firmly)

Approximate time for you to complete
The task is straightforward even so the additional time you would spend considering the project, the more significant the improvement on your home.

Level of Risk
Medium – always take care when you use a saw and, hammer and nails.

Why are we carrying it out

When you’ve got unsightly pipe work you want to cover up, boxing-in is the perfect option.
It is cheap as well as relatively easy to complete and it is used to enhance the overall look of one’s rooms.

The way to do it (With Simple tips)

1) Assess the scale of the work

Should you be dealing with a individual pipe then a easy box work is the easiest solution.
Consider whether or not you should include entry to valves or stop taps etc.
When you are constructing a larger box i e to. to cover more than one pipes you will need to take more time so that you can plan the work.

2) Pick the material

The material useful for single pipe box work must be solid enough to resist nailing ( splitting).
Particle board or even MDF is ideal for this job.

3) Take the measurements

Properly measure the total length of the box work necessary.
The height of the box work will be based on the height of the pipe and the width will depend on the actual diameter of the pipe plus the distance in the wall it runs along. Draw these measurements ones timber or even plywood.
If you are handling hot water pipes they should be insulated to prevent the heat escaping and you should really need to allow room for this.

4) Trim your wood to suit

By using a tenon saw and a vice in order to firmly hold your wood in place to cut along the designated lines.

5) Trim your batten and secure on the wall structure
Cut the actual 12mm thick rectangular batten to the entire box work. While using drill and also screws secure this to your wall.
The top panel of the box (the cover) will rest on this.
Secure another batten horizontally onto the underside of the lid. The side panel of the box is going to be screwed onto this.

6) Construct your box work and secure to the batten

Using best suited screws attach the actual panels to the edge of the battens.
Should the screw actually to large it can spread the wood and leave the surface of the boxing bumpy.

The same strategy is used in vertical piping.

7) Corner pipes (three sided box work)

To be able to box in pipes first measure and secure 12mm thick rectangular battens to the walls on each side of your pipe.
Next screw a piece of wood to each of the battens.
The timber ought to protrude from the wall a few mm more than the actual pipe. Finally fit a third panel between your timbers and screw into position.

8) To get having access to valves and stop taps

If you wish to gain access to the valves and also stop taps slide a washer (a soft metal ring to fit the shaft of the screw) onto the screw before you insert the screw into the hole.
This will make it easier to undo the screw when you need to reach the valves or stop taps.

9) Cover the box work

Finally, to make the box work more great looking you could consider covering it with tiles maybe wallpaper or when it is a low horizontal pipe you may think about extending carpeting to cover the box.

The UKs fastest growing online retailer specialising in Power Tools, Hand Tools and Automotive Tools
http://www.toolbox.co.uk/
http://www.toolbox.co.uk/cordless-drills-4940-0000
http://www.toolbox.co.uk/hand-saws-2798-0000

No Comments

Leave a Comment